|
| Posted on 8/26/08 at 05:02 AM | |
|
| In addition to my response to your other post, if your platens are uneven left to right, you may want to remove one of the roll pins from the platen bracket where it engages the hole on the press carousel, and adjust the bracket to where you can level it, then bolt the bracket up tight. Front to back leveling is accomplished by the bolts behind the plate on the carousel to which the platen bracket attaches. Unless the welding is extremely out of square, there should be enough adjustment that you can get the press components aligned. I had mine set up pretty good before I sold it, and it held registration once I got the screens registered. As I mentioned, the micros were the weak spot. Oddly, their hat presses are well regarded. | |
  
|